Well, after playing around with the RAID array throughout the wee hours of the morning, it’s pretty apparent that something went seriously wrong.  A massive power flux?  A dicey hard drive?  I really don’t know at this point.  S.M.A.R.T. status on all the drives shows that they’re running just fine.  So far 2 ideas are floating around in my head:

1. The system suffered a massive power fluctuation that totally ticked off the Mac, or the RAID unit, or both.
2. There is a major compatibility problem with the RAID unit and the HighPoint Technology card that I had to use in place of the bundled controller card.  The only thing I can think of is that there might be 2 different chipsets between the RAID unit and the controller that don’t like each other at all.

Either way, I’m glad this problem decided to rear its head NOW instead of later, when we’ve got the drive populated with irreplaceable data.

Speaking of which, it just so happens that most of the files that were on that RAID5 array are still sitting in other areas!  THAT is letting me breathe so much easier right now.  However, there were quite a few Final Cut project files that were only on that array, which is still a bummer.  I’m in the process of looking through data recovery software to see if there’s anything decent that I can try.

In the meantime, I’ve got a UPS set hook into that system immediately.  Plus, if I can’t make the array work after another rebuild, I’m doing to set a separate PC up there and connect it to the MacPro.  Since the PC has a PCI slot on it, I can use the Norco’s bundled controller card.  I’m not exactly thrilled about putting a PC up there JUST to act as a bridge between the editing system and the RAID, but I may find that I have no choice.

More updates as the plot unfolds.